RGBW led chip is the new chip,which have R,G,B,W four color chips inside one 5050 SMD LED.
The white color is much puerer and higher brightness.Can be controlled by wifi remote and cell phone(Android ,IOS).
Change any color and dimmable as you want at any time.Can be DC12V,DC24V,
30 leds LEDs per meter.
RGBW(White coloe insde could be warm white:2800-3200K,nature white:4000-4500K,pure white:6000-6500K. )
LED Type: SMD 5050 RGBW
Color: warm white, white, nature white
LED Quantity: 30 led per meter -- 60 84 96 leds/Meter optional
PCB width: 12MM
Working Input Voltage: 24V
Drive Mode: Contant Voltage
This is a PWM control RGB color LED strip without Pixel SMD RGBW 5050 LEDs ,
5meters/reel, 12mm PCB width The cutting unit length is 50mm(12V), or 100mm(24V) per section The PCB is made by 2 Ounce 35um thick copper All soldering Pads are very large, allowing you to easily cut and reconnect DC12/24V constant voltage operation Both ends have 4pin bare wires for powering 3M tape attached on backside of FPC
Installing : non-waterproof: with 3M adhesive on back side for sticky; waterproof: screw+silicon clip, or 3M adhesive back side.
there is other rgbw led strip optional
IP20: Non-waterproof with 3M sticker on the back,
IP65: waterproof is silicone gel or epoxy on the surfacewith 3M sticker on the back,
I67: silicone tube
I68: silicone glue inside the silicone tube
•Widely used for home decoration use, hotels, clubs, shopping malls
•Decorative lights for holiday, event, show exhibition
•Applicable for automobile and bicycle decoration, border or contour lighting
Do not use any acidic, alkaline adhesive fixing Product
It is prohibited to make products with a hard object collision, friction Do not use your fingers to press LED Don’t make positive and negative reversed Don’t install when product is working Installation, repair and maintenance must be made by professional Person Before you use them make sure the power supply voltage to meet the requirements and wire connection correctly